Abstract & Overview
The objective of the study is the development of 3D variable-length link model with electric drives to be used in designing of next-generation comfortable exoskeletons. The developed link model has two inertial absolutely rigid sections on its ends and a variable- length section, considered weightless, in between. The mechanical part of the variable-length link model has been implemented in the universal computer math "Wolfram Mathematcia 11.3" environment by building the system of Lagrange – Maxwell differential equations. The electro-mechanical link model with electric drives has been implemented in the MatLab Simulink environment. The implemented model includes the following units: the trajectory synthesis unit per each degree of freedom, the unit for controlling torques calculation based on differential equations of motion, the unit for selecting electric motors with gears, the unit for calculating electric current per each motor and implementing the control system. The electric motors, reducers, rack and pinion gears implementing the specified and programmed link motion have been selected. The inertial and geometrical variable-length link parameters corresponding to the human tibia in the period of the single-support step phase have been selected. The drives implementing the link rotation are situated in the bottom link point in the combination of two orthogonal cylindrical hinges. One of these hinges is fixed to the supporting surface, the other one is fixed to the link end. This hinge combination simulates human ankle joint in the single-support step phase. The drive controlling the link length change is situated at the end of the bottom absolutely rigid weighty link section. The programmed trajectories for generalized coordinates are specified based on the simulation requirements of the anthropomorphic tibia motion. As a result, the electro-mechanical model of a variable- length link with parameters corresponding to the average man’s tibia has been developed. The drives and gears that allow implementing the motion close to anthropomorphic one have been selected. The implementation of this motion based on the developed software in the computer math "Wolfram Mathematica 11.3" environment and in the MatLab Simulink system has been demonstrated. The numerical calculations are presented.